Warning, Electrical shock or personal injury hazard, To remove light bulb – Kenmore 116.34924 User Manual
Page 17: Caution, Note: see parts and features for, Agitator cleaning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
performing maintenance to the unit.
Failure to do so could result in
electricai shock or personal injury
from the vacuum cleaner suddenly
starting.
TO REMOVE LIGHT BULB
1. Disconnect power cord from electrical
outlet.
2. Pry light lens
out at slot in rear
as shown on both
sides. Rotate lens
up and lift off.
A
CAUTION
Do not use a bulb rated over 9W
(13V). During extended use, heat from
the bulb could overheat surrounding
plastic parts.
3. Remove the light
bulb by pulling straight
out.
4. To replace the
light bulb, carefully
insert fully into slot.
Note: See PARTS AND FEATURES for
bulb number.
A
CAUTION
Do not plug in or turn on until the
vacuum cleaner is completely
reassembled.
To replace light
lens, place tabs at
front of lens into
slots. Rotate lens
down and snap
Into place.
Light
L e n s '^
^
AGITATOR CLEANING
To maintain efficient cleaning, the agitator
must be kept free of carpet fiber, string, or
hair build-up. After every 7 to 10 uses,
unplug and turn vacuum cleaner over and
check agitator for fiber and hair build-up.
Use scissors to remove any build-up entan
gled around the agitator.
17