Kenmore 116.34924 - Manual (Page 15)

TO REMOVE DUST BAG
A
WARNING
Always unplug power cord from
electrical outlet before performing
any maintenance on the vacuum
cleaner.
1. Pull out on the
bag cover release
located near the
top of the bag
cover. Bag Cover
Release­
Bag
C o v e t s
L
2. Pull the bag
cover fon/vard
and lift up.
Remove and lay
aside.
3. Grasp the dust bag
collar and pull gently,
carefully removing
the dust bag.
4. Throw away the
used dust bag.
Do not reuse dust bag.
>ML!_ Bag
Bag Cavity
Motor
Safety
Filter
Check the bag
holder and the
motor safety fil­
ter. If either is
blocked, check
TROUBLE­
SHOOTING.
A
CAUTION
NEVER REUSE A DUST BAG. Very
fine materials, such as carpet fresh­
ener, face powder, fine dust, plaster,
soot, etc. can clog the bag and
cause it to burst before it is full.
Change bag more often when vacu­
uming these materials.
Safely
Seal Tab
TO REPLACE DUST BAG
1. Unfold the
new dust bag.
Fold the safety
seal tab on the
new dust bag
away from the
opening that
fits on the bag
holder.
NOTE: See PARTS AND FEATURES for
bag number.
2. Insert the dust
bag onto the bag
holder completely
by holding the bag
collar.
3. Place the dust bag
collar into position.
4. Tuck the bag
behind each of the
four bag retention
corner flaps shown
here. Be sure the
bottom and sides
of the dust bag are
completely within
bag cavity prior to
replacing the bag
cover.
Sag
Retention
Comer
Flaps
5. Position the bag
cover so its posi­
tioning tabs fit into
the body position­
ing tab slots.
6. Close the bag
cover.
You will hear a
distinct snap
when cover is
securely closed.
Check to see that the dust bag is fully
enclosed In the bag cover.
15