beautypg.com

Parts supplied, Explosion hazard, Parts needed – Kenmore ELITE OASIS 110.6707 User Manual

Page 5: You will need, Installation instructions, Awarning, C . . i€nts

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

INSTALLATION INSTRUCTIONS

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.

Flat-blade screwdriver

#2 Phillips screwdriver

Adjustable wrench that
opens to 1" (2.5 cm) or

hex-head socket wrench
(for adjusting dryer feet)

Wire stripper (for direct
wire installations)

Tin snips (new vent

installations)

Level

Vent clamps

Caulking gun and
compound (for installing
new exhaust vent)

Tape measure

Parts supplied:
Remove parts package from dryer drum. Check that all parts

were included.

^ ■ c . . i€nts

AWARNING

w

Explosion Hazard

Keep flammable materials and vapors, such as
gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor

for a garage installation.

Failure to do so can result in death, explosion, or fire.

4 leveling legs

Parts needed:

Check local codes, check existing eiectrical suppiy and venting
and see “Eiectrical Requirements” and “Venting Requirements”
before purchasing parts.

Mobile home installations require metal exhaust system hardware
available for purchase from your local Sears store or Sears
Service Center. For further information, please call
1-800-4-MY-HOME® (1-800-469-4663).

You will need
■ A location that allows for proper exhaust installation. See

“Venting Requirements.”

■ A separate 30-amp circuit.

■ If you are using a power supply cord, a grounded electrical

outlet located within 2 ft (61 cm) of either side of the dryer.
See “Electrical Requirements."

■ A sturdy floor to support the total weight (dryer and load) of

200 lbs (90.7 kg). The combined weight of a companion
appliance should also be considered.

■ A level floor with a maximum slope of 1" (2.5 cm) under entire

dryer.

Do not operate your dryer at temperatures below 45“E (7°C). At
lower temperatures, the dryer might not shut off at the end of an
automatic cycle. Drying times can be extended.

The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes or
sleeping quarters. Contact your local building inspector.

This manual is related to the following products: