beautypg.com

Optional 3-wire connection – Kenmore ELITE OASIS 110.6707 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

When connecting to the terminal block, place the hooked end of
the wire under the screw of the terminal block (hook facing right),
squeeze hooked end together and tighten screw, as shown.

1.

2

.

Loosen or remove center silver-colored terminal block screw.

Place the hooked end of the neutral wire (white or center wire)
of direct wire cable under the center screw of terminal block
(hook facing right). Squeeze hooked end together. Tighten
screw.

A. External ground conductor screw
B.
Neutral ground wire
C. Center silver-colored terminal block screw
D. Neutral wire (white or center wire)

E.

¥4

(1.9 cm) UL listed strain relief

3. Place the hooked ends of the other direct wire cable wires

under the outer terminal block screws (hooks facing right).
Squeeze hooked ends together. Tighten screws.

4. Tighten strain relief screw.

5. Insert tab of terminal block cover into slot of dryer rear panel.

Secure cover with hold-down screw.

6

.

You have completed your electrical connection. Now go to

“Venting Requirements.”

Optional 3-wire connection

Use for direct wire or power supply cord where local codes
do not permit connecting cabinet-ground conductor to
neutral wire.

1

.

2

.

Remove center silver-colored terminal block screw.

Remove neutral ground wire from external ground conductor
screw. Connect neutral ground wire and the neutral wire
(white or center wire) of power supply cord/cable under
center, silver-colored terminal block screw. Tighten screw.

A. External ground conductor screw
B. Neutral ground wire
C. Center silver-colored terminal block screw
D. Neutral wire (white or center wire)

E. W (1.9 cm) UL listed strain relief
F. Grounding path determined by a qualified electrician

3. Connect the other wires to outer terminal blook screws.

Tighten screws.

4.

5.

Tighten strain relief screws.

Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down screw.

Connect a separate copper ground wire from the external
ground conductor screw to an adequate ground.

12

This manual is related to the following products: