To clean agitator, To replace belt – Kenmore 116.23637C User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TO CLEAN AGITATOR

NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacu
um, the agitator must be cleaned every time

the belt is changed.

The agitator must also be cleaned accord

ing to the following schedule:

Vacuum Use

HEAVY -

(used daily)

MODERATE -

(used 2-3 times/week)

LIGHT -

(used 1time/week)

Clean Agitator

every week

every month

every 2 months

TO REPLACE BELT

1. Install new
belt over motor

drive, then
over brush
sprocket.

NOTE: See

PARTS AND
FEATURES for

belt number.

Motor

Drive

End Cap

Agitator

2. Place agitator
assembly back
into Power-Mate®!

3. Reinstall
agitator
cover by lin
ing up the

front tabs

and slots
and rotating
downward

until the

latches snap into place.

4. Line up
front of

cover and

base. Rest

cover on

front edge

of base as
shown.

5. Rotate cover

back. Press

cover firmly

until side and
rear tabs snap

into place. Turn

Power-Mate®

upside down

and replace two

(2) cover

screws.