Edge cleaner, Overload protector, Suction control – Kenmore 116.23637C User Manual
Page 11: Warning, Auto-cleaning system, Power-mate® storage, Thermal protector
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EDGE CLEANER
Active brush edge
cleaners are on
both sides of the
Power-Mate®.
Guide either side
of the Power-Mate®
along base-boards
or next to furniture
to help remove dirt
trapped at carpet
edges.
OVERLOAD PROTECTOR
The Power-Mate* has
built-in protection
against motor and belt
damage should the
brush jam. If the brush
slows down or stops, the
overload protector button
pops up and shuts off
the Power-Mate®. The
canister motor will continue to run.
To correct problem:
See
TROUBLESHOOTING.
To reset:
Push in the overload protector
button.
SUCTION CONTROL
5 o r ,
Decrease
Suction
Increase
Suction
The suction
control allows
you to change
the vacuum
suction for
different fabric
and carpet weights. Opening the control
decreases suction for draperies and
lightweight rugs,‘while closing the control
increases suction for upholsteries and
carpets.
A
WARNING
Personal Injury Hazard
Always unplug the vacuum cleaner
before cleaning the brush area as
brush may suddenly restart. Failure to
do so can result in personal injury.
AUTO-CLEANING SYSTEM
This vacuum is equipped with an auto-clean
ing system. Each time the power cord is
extended a cleaning cam located inside the
dust bin rotates and cleans the filter.
POWER-MATE® STORAGE
The lower wand has
a “U” shaped flange
in the area where
the power cord
attaches. The canis
ter has a “U”
shaped slot near '
the rear of the canis
ter.
The slot allows the wands and Power-Mate®
to be stored with the canister to conserve
storage space.
The wand will slip out of the slot as it is lift
ed up for use and will slide into the slot as it
is lowered for storage.
THERMAL PROTECTOR
This vacuum has a thermal protector which
automatically trips to protect the vacuum
from overheating. The thermal protector
turns the motor off automatically to allow the
motor to cool in order to prevent possible
damage to the vacuum.
To reset
Turn off and unplug the vacuum
from the outlet to allow the vacuum to cool.
Check for and remove any clogs. Also
check and replace any clogged filters. Wait
approximately 30 minutes and plug the
vacuum in and turn back on to see if the
thermal protector has reset. In some cases,
the unit may suddenly restart. DO NOT
leave unattended while plugged in.
11