Step 1: install cold water supply fitting – Kenmore ULTRAFILTER 300 625.384720 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
- STEP 1: INSTALL COLD WATER SUPPLY FITTING -
Check and comply with local plumbing codes
as you plan, then install a cold feed (supply) water fitting. The
fitting must provide a leak-tight connection to the RO 1/4" tubing (see FIG. 8, page 8). A typical connection
using the included water supply fitting is shown in
F1G.3 - A
below. An optional connection, using standard
plumbing fittings (not included), is shown in
B.
Note: Codes in the state of Massachusetts require installation by a licensed plumber, and do not permit the use of a saddle
valve.
For installation, use plumbing code 248- CMR of the Commonwealth of Massachusetts.
A. WATER SUPPLY FITTING
B. OPTIONAL PIPE FITTINGS
(compression type
l.Closethe house main water shutoff valve and open
shown)
faucets to drain water from the sink cold water pipe.
2, Remove nut that connects the cold water faucet to
cold water plumbing.
3,
Use pipe joint compound or Teflon tape on
cold water
faucet stud
threads and on the male threads of the
water
supply fitting
that connect to the
cold water pipe,
4,
Thread water supply fitting onto pipe and recoimect
nut to bottom of fitting.
Note:
Be sure to turn off the water supply and open
a low faucet to drain the pipe.
Complying with plumbing codes, install a fitting on
the kitchen cold water pipe to adapt 1 /4" OD tubing.
A typical connection is shown in figure 3B. If
threaded fittings are used, be sure to use pipe Joint
compound or Teflon tape on outside threads.
FIG.3
A.
WATER SUPPLY CONNECTION
(using included water supply fitting)
B.
WATER SUPPLY TYPICAL CONNECTION
(using compression fitting)
- parts not included -
Problems, Questions? Call 1 -800-426-9345 Kenmore Water Une