Kenmore ULTRAFILTER 300 625.384720 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
- TABLE OF CONTENTS -
Where To Install the RO System...............
. 4
Installation Steps - continued
Tools and Materials Needed ......................
4
Sanitizing, Pressure Test, Purging .. .. 9
Installation Steps ........................................
. 5-9
How the RO System Works .................... .. 10-11
Cold Water Supply...................................
. 5
Care of RO System .................................. .. 12-15
Drain Adapter .........................................
. 6
Dimensions, Specifications ...................... .. 16
Faucet .......................................................
. 6-7
Remote Installation Locations ................ .. 17
RO Assembly ...........................................
. 7
Repair Parts ............................................. .. 18-19
Storage Tank, Tubing Connections ...
. 8
- WHAT YOUR REVERSE OSMOSIS SYSTEM WILL DO -
Your Reverse Osmosis (RO) Drinking Water System
is a water treatment unit. It uses household water
pressure to reverse a natural physical process called
osmosis. Water, under pressure, is forced through a
semi-permeable membrane where minerals and im
purities are filtered out. Clean drinking water goes to
the faucet or storage, while minerals and impurities
are sent to the drain with RO waste water. The miner
als and impurities are measured in water as total dis
solved solids (IDS).
RO membrane. The postfilter removes any tastes
and/or odors that may remain in the water, after
passing through the RO membrane, and just before
going to the RO faucet. To prevent water waste, an
automatic shutoff valve closes when the RO faucet is
closed and the storage tank is full.
Your reverse osmosis system gives you a continuous
supply of sparkling clear, delicious water for drink
ing, cooking and other uses. Foods will look and
taste better too. Having high quality RO product wa
ter at your fingertips eliminates the need to buy
bottled water. The storage tank holds over 2 gallons
of RO product water for your needs.
The system includes replaceable pre and postfilter
sediment-carbon cartridges. The prefilter removes
sand, silt, dirt, rust particles, other sediments, and
chlorine from the water supply before it can enter the
- BEFORE YOU BEGIN TO INSTALL THE RO SYSTEM -
FOR OPTIMUM PERFORMANCE YOUR KEN-
MORE REVERSE OSMOSIS SYSTEM SHOULD BE
INSTALLED ON
SOFTENED
WATER.
CAUTION:
A refrigerator icemaker may not operate
properly when connected to a reverse osmosis sys
tem that has been installed on a water system that op
erates outside of the specified pressures listed on
page 16.
Check Your Water Supply:
The cold water supply to
the RO system must be within certain quality limits.
See the specification table on page 16. If supply water
is not within limits, the RO system can not make
product water as it should and reduced RO mem
brane life will result.
Trained sales people at Sears can arrange for a free
water analysis. The analysis will tell you if other wa
ter supply treatment is needed before going to the
RO system.
CAUTION: Chlorine
in the water
will destroy the
RO membrane-
Most cities add chlorine to the wa
ter supply to kill bacteria. The prefilter removes
chlorine up to the limits shown in the specifications
before it enters the RO membrane. It is
important
to replace the prefilter cartridge
at least every 6
months. See the RO care guide on page 16.
Check Parts Included:
Unpack the carton and re
move the RO system. In addition to the assembled
RO and the storage tank, the system includes the
parts illustrated below, a separate length of tubing,
and this manual.
FIG. 1
HANQER WASHERS
& SCREWS
RO PRODUCT
WATER FAUCET
TEFLON
TAPE
TUBING
ADAPTER
WATER SUPPLY
FITTING
AA BATTERIES
(MONITOR
MODEL)
Problems, Questions? Call 1 -800-426-9345 Kenmore Water Une