beautypg.com

To clean, Surtace burners – Kenmore 665.75022 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Surtace Burners

2.

Burner base

3. Alignment pins

4. Ignitor
5. Gas tube opening

IMPORTANT:

Do not obstruct the flow of combustion and

ventilation air around the burner grate edges.

Burner cap:

Always keep the burner cap in place when using a

surface burner. A clean burner cap will help prevent poor ignition
and uneven flames. Always clean the burner cap after a spill-over

and routinely remove and clean the caps according to the
“General Cleaning” section.

Gas tube opening:

Gas must flow freely throughout the gas tube

opening for the burner to light properly.

Keep this area free of

soil and do not allow spills, food, cleaning agents or any
other material to enter the gas tube opening.

Protect it from

spill-overs by always using a burner cap.

Burner ports:

Check burner flames occasionally for proper size

and shape as shown below. A good flame is blue in color, not
yellow. Keep this area free of soil and do not allow spills, food,

cleaning agents or any other material to enter the burner ports.

To Clean:

IMPORTANT:

Before cleaning, make sure all controls are off and

the oven and cooktop are cool. Do not use oven cleaners, bleach
or rust removers.

1. Remove the burner cap from the burner base and clean

according to the “General Cleaning” section.

2. Clean the gas tube opening with a damp cloth.

3. Clean clogged burner ports with a straight pin as shown. Do

not enlarge or distort the port. Do not use a wooden

toothpick. If the burner needs to be adjusted, contact a
trained repair specialist.

4. Replace the burner cap, making sure the alignment pins on

the cap are properly aligned with the burner base.

1. Incorrect

2. Correct

5. Turn on the burner. If the burner does not light, check cap

alignment. If the burner still does not light, do not service the

sealed burner yourself, contact a trained repair speciaiist.

1. I - I V

2

" (23-38 mm)

2. Burner ports

8

This manual is related to the following products: