Kenmore ASPIRADORA 116.35623 - Manual (Page 18)

NOTE: See PARTS AND FEATURES for
belt number.
Iroop the other end of the belt on the belt
pulley on the agitator.
Insert the agitator by placing the rounded
portion of the end cap down into the slot
in the nozzle base.
Note: It may be necessary to hold the fur­
niture guard out of the way in order to
allow proper insertion of the agitator into
the nozzle base.
Note: Care must be taken due to the belt
tension during reassembly.
Press firmly,
checking to
see that
each end is
completely
inserted.
Check to see that the belt is centered on
the belt pulley. Turn the agitator with your
fingers to see that it turns freely.
To re-attach
the agitator
cover, insert
the
six (6)
tabs into the
six slots
along the
front edge of
the nozzle
base.
Lower the agitator cover to its original
position. After positioning the agitator
cover, push forward on the two (2) locking
tabs in order to ensure that they are
securely in place.
Re-fasten
the furniture
guard retain­
ers to the
posts on
both sides of
the agitator
cover.
Furniture
Guard
Retainer
JÔ
Agitator
Cover
Note: If the agitator cover is not installed
correctly, you may experience a loss of
performance and possible agitator vibra­
tion, etc.
Make sure the headlight wires are tucked
securely in place.
Replace the
nozzle cover
and secure
the latches.
18