Kenmore 911.93508 - Manual (Page 26)

CARE AMD CLEAmMB
Removable Parts (cent.)
REiyJO VABLEO VEN RA CKS
CLEANING MATERIALS
• Dishwashing detergent
• Warm water
• Scouring pad or soap-filled
steel-wool pad
Bump
REMO VABLEO VEN DOOR
TO REMOVE
1. Pull the racks out to the stop
position.
2. Pull up the front of the rack and
slide under the bump of the rack
guide.
TO CLEAN
Clean with warm water and detergent.
For hard-to-remove stains, gently
scrub with a scouring pad or a
soap-filled steel-wool pad. Rinse well.
TO REPLACE
1. Place the raised back of the rack
onto the rack guides.
2. Lift the front of the rack until the
raised back slides under the bump
of the rack guides.
3. Slide the rack all the way back.
TO REMOVE
1. Fully open the
door.
2 . Push the hinge
locks down
toward the door
frame, to the
unlocked
position. This
may require a
flat-blade
screwdriver.
3. Firmly grasp both
sides of the door
at the top.
4 . Close door to the
door removal
position.
5. Lift door up until
the hinge arm is
clear of the slot.
Hinge Leek
(UnlockBd
Poaltton)
Hinge Arm
Removal Position
TO REPLACE
1, Firmly grasp both
sides of the door
at the top.
2. With the door at
the same angle
as the removal
position, seat the
indentation of the
hinge arm into
the bottom edge of
the hinge slot.
Bottom
Edge of Hinge
Arm
Indentation
26
20P1836ENv0l4)ni6 26 2a«D0,9dSAM