Operatioh, Ovett control^ clock, atto timer (eonl) – Kenmore 911.93508 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATIOH
Ovett Control^ Clock, attO Timer (eonL)
F-CODES
If the display flashes an “F” followed
by a number and beeps continuously,
you have a function error code.
Note the number after the "F.” Turn
the oven control knob to the OFF
position, Disconnect all power to the
range for at least 30 seconds and
retry the oven operation. If the “F”
displays during a self-clean cycle,
check the oven door latch. Make sure
the latch is moved to the right as
far as it wiii go. Turn the OVEN
CONTROL KNOB to the OFF
position. Ailow the oven to cool 1 hour
and retry the oven operation. If the
problem repeats, call for service.
Advise the technician what the
flashing code was.
PF CODE
When the power to your range is
turned on for the first time, or if you
experience a power failure, the
display wilt flash “PF." By touching
the CLOCK pad. the display will flash
“12:00." Touch the CLOCK pad again
and follow the instructions to set the
clock. Any operation set before a
power faiiure will need to be reset.
AUTOMATIC
OVEN SHUTOFF
The oven will automatically shut off
if it has been left on for more than
12 hours.
To deactivate or reactivate the
automatic shutoff, touch and hold the
MIN UP and DOWN arrow pads for
about 4 seconds.
11
20PrS36ENv01.pilie
11
2f2AKO. 9-34 AM