Care amd cleamme, Self-cleaning cycle, Kiwi – Kenmore 911.93508 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CARE AMD CLEAMme
Self-Cleaning Cycle
PREPARING YOUR OVEN
FORA SELF-CLEAN CYCLE
1
.
2
.
Remove the broiler pan and grid,
oven racks, utensils, and any foil
that may be in the oven.
Soil on the front frame and outside
the gasket on the door liner will
need to be cleaned by hand.
Front
Frame
Clean these areas with hot water,
soap-filled steel-wool pads, or
cleansers such as Soft Scrub*” to
remove any soil. Rinse well with clean
water and dry.
3. Wipe up any heavy spillovers on
the oven bottom.
4.
Do not clean the gasket. The
fiberglass material of the oven
door gasket cannot withstand
abrasion. It is essential for the
gasket to remain intact. If you
notice it becoming worn or frayed,
it should be replaced.
OVEN DOOR CASKET
The gasket is designed to have a
5'-6" gap at the bottom of the door.
This allows for proper air circulation.
Door Panel
Gasket
KIWI
Door Uner
It is normal for your oven door to give
the appearance of not having a good
seal against the range. This is due to
the gasket. The location of the gasket
on the door maintains a good seal
and prevents arty heat loss.
Utensils should never be
left In the oven during a
seN-clean cycle.
The oven racks may be cleaned
during the self-clean cycle, but
will lose their luster and become
hard to slide. If you choose
to leave them In during the
cycle, wiping them down with
vegetable oil after the cycle will
help them slide easier.
For the first clean cycle, vent the
room with an open^ window or
hood vent. This will reduce the
odor produced when heating
new parts.
20
20P1S36E№0l4Hn6
20
2/24^» 9:35 AM