Care and cleaning, Rib clear groove in stem spring clip – Kenmore 911.93508 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CARE AND CLEANING
CONTROL KNOBS
CLEANING MATERIALS
• Dishwashing detergent
• Warm water
• Soft cloth
Molded
Rib
Clear
Groove
In Stem
Spring Clip
TO REMOVE
1. Be sure the control knob is in the
OFF position.
2.
Pull straight off the stem. Using a
piece of string can make removing
the knob easier. Slip the string
under and around the knob,
pulling straight out.
TO CLEAN
Wash the knob thoroughly with
soapy water. Dry completely with
a soft cloth. DO NOT let the
knob soak.
TO REPLACE
1. Check the back of the knob.
2
.
The molded rib of the knob is
designed to fit perfectly onto the
knob stem.
3. Align the moided rib to the clear
groove in the knob stem. Push the
knob back as far as it will go.
REPLACING
THE OVEN LIGHT BULB
CAUTION:
Disconnect electrical
power to the oven at
the main circuit breaker
or fuse box before attempting to
replace the oven light bulb. Do
not touch a hot light bulb with
wet hands or a wet cloth. Wait
until the bulb has cooled and
use a dry cloth.
TO REPLACE
1
.
Hold your hand under the bulb
cover and firmly push back the bail
wire, until it clears and releases the
bulb cover.
2. Unscrew the light bulb.
3. Replace the bulb with a
3W
40-watt appliance bulb.
4. Place the bulb cover into the
grooves of the socket and puli the
bail wire forward until it rests in the
indentation on top of the bulb
cover.
¿4
20P1836ENv0l4>ine
2S«0a,9:3SAM