Kenmore 15828 - Manual (Page 9)

Ctanging a e^cle
Cancel/Drain
To change a cycle:
o During the first two minutes of operation while
filling, simply select a new cycle,
OR
CAIREL
DRAIN
« After the first two minutes, press Cancel/Drain,
wait two minutes, and select a new cycle.
(Remember to add detergent if the dishwasher
has already gone through the wash portion of
the cycle )
©pti@fis
Automatic Preprogramming
Any option can be automatically preprogrammed
by pressing and holding the desired option pad.
The pad will beep when you first press it, then
beep a second time while you continue to press it.
Release the pad after the second beep, The option
will automatically be chosen whenever you select
a cycle with which the option normally works. To
turn off a preprogrammed option, press and
release the option pad, then press and hold the
option pad until the pad beeps a second time.
No Heat Dry
Use this option to dry dishes in room temperature
air and save energy When you
select No Heat Dry, drying will take
longer than heat drying, and water
spotting can occur. It is important
to use rinse agent when selecting
this option.
® Use this option when you do not plan to unload
the dishwasher for several hours.
Water Heat
Use this option when washing heavily soiled dishes
When you select Water Heat, the main
wash will delay until the water heats
to 135®F (57”C). As water heats,
washing action will continue and the
Water Heat light will glow; however,
the electronic time display will pause,
o The Pots Pans cycle automaitcaily uses Water Heat.
® Selecting the Water Heat option will not cause water
to be heated during Quick Rinse or China Ught cycles.
WATER
HEAT
Cancel/Drain
When this option is selected, the dishwasher will
stop and any water in it will drain.
Draining will take about two minutes.
When draining is complete, all signals
wiil turn off. You may then select a
new cycle, if you wish.
Sani Rinse
Sani Rinse is available in Pots Pans, Normal Wash,
and Water Miser cycles. When this
option is selected, water for the final
rincjo |c
iri hiiih
I It lOw iw i iwClLwU iiW Ur ivSlJl Ci I riUi I
temperature, sanitary rinse. The
cycle time will be extended until the
water reaches the proper ternpera-
ture. The Water Heat light glows and washing
action continues while the water heats. The Sant
Complete light glows at the end of the cycle
indicating a high temperature, sanitary rinse
was completed
SANI
RINSE
NOTE: A flashing Sani Complete light indicates
that a high temperature, sanitary rinse was not
completed The Sani Complete light wiil flash at the
end of the cycle if the dishwasher door is opened,
power fails, or water heating is not completed
during the final rinse. You may need to turn your
water healer temperature up so water is at least
120°F {49‘’C) as it enters the dishwasher,