beautypg.com

Kenmore 15828 User Manual

Page 26

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Please check the chart below for problems you can fix,. It could save you the cost of a service call
If you still need help, see “Sears Repair Services” toll-free numbers on page 27,

PROBLEM

CHECK THE FOLLOWING

Dishwasher

does not run
or stops during
a cycle

is the door tightly closed and securely latched?

Has the cycle been set correctly?
Has a household fuse or circuit breaker blown or tripped?

is the delay feature on?
If the motor has stopped because of an overload, it will automaticaliy reset itself

within a few minutes, if the motor does not start, cali for service.

Is the water supply turned on?

Dishwasher
seems to run

too long

The dishwasher wiil run longer while heating water. This is norma!, The time show­

ing on the electronic display will pause while water is heating. See pages 9 and 10,
If the water temperature is below 135“F (57°C):

0

a delay will occur in the main wash if the Water Heat option is selected

° three delays will occur if the Pots Pans cycle is selected.
® the final rinse will automaticaliy delay unti! the water temperature reaches

135“F (57“C),

Dishwasher

1 will not fili

Is overfill protector stuck in “up" position? Overfül protector should move up and
down freely. Press down to release.

Water remains

in dishwasher

Wait for the cycle to finish. A small amount of water remaining is normal.
Check the drain air gap accessory (if installed) to see if it is clogged.

Detergent
remains in cov­
ered section of
dispenser

Has the cycie compieted?
Is the detergent fresh and dry without lumps?

Is the bottom rack in backwards? The rack bumpers should face the door.

Dishes are not
as dry as you
expected

is the rinse agent dispenser empty? Using a rinse agent greatly improves drying.
See page 12.
Do not use No Heat Dry option on the next load..

Grinding, grating,
crunching, or

1 buzzing sounds

Has a hard ob|ect entered the ULTRA WASH™ module? The sound should stop
when the object is ground up.

1 White residue
1 appears on front
1 of access pane)

Is too much detergent being used? See page 11 for recommended amounts of

" detergent.

Some liquid detergents develop excess foam and buildup on access panel. Try a
different brand to reduce foaming and eliminate buildup.

26

This manual is related to the following products: