beautypg.com

Fig. 1), Care & cleaning, Surface elements and drip bowls – Kenmore 970-5984 User Manual

Page 28: Ik caution

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Care & Cleaning

Surface elements and drip bowls

Surface elements may appear to have

cooled after they have been turned off. The surface

elements may still be hot and burns may occur if touched

before they have cooled sufficiently.

ik CAUTION

Protective liners — Do not use aluminum

foil to line surface drip bowls, or reflector pons. Only use

aluminum foil os recommended in this manual. Improper

installation of these liners may result in risk of electric

shock, or fire.

Surface elements may be unplugged and removed to moke

cleaning the drip pons easier. The surface elements clean

themselves when they ore turned on. Food spilled on o hot

element will burn off. Food spilled on o COOL element

may be cleaned with o damp cloth — any remaining soil

will burn off the next time the element is used.

To remove the surface elements and drip bowls:

1. Lift the edge of the drip bowl across from the terminal

end. Lift the surface element and drip bowl together just

enough to clear the cooktop.

2. While holding the drip bowl and surface element,

gently pull the terminal end out from terminal plug (See

Fig. 1).

Allow element

support to rest on

drip pan inside rirr

Terminal end

Cleaning drip bowls

Wash in hot, soapy water or in the dishwasher. Rinse and

dry while still warm. Hard to remove, burned on soil con be

removed by soaking the drip bowls for about 20 minutes in

o lightly diluted liguid cleanser or o solution of ammonia

and water (1 /2 cup ammonia to 1 gallon of water).

A no-scrotch scrubbing pod may be used after soaking.

DO NOT use abrasive cleaners or steel wool, they will

scratch the surface. Always rinse with clean water and

polish dry with o soft cloth.

To replace drip bowls and surface elements:

1. Slide the terminal end on the surface element through

the opening in the drip bowl (Refer to Fig. 1).

2. Align the surface element support to rest on the rim

inside the drip bowl.

3. After the surface element is positioned in the drip bowl,

line up the terminal end with the terminal plug os shown

(Fig. 1).

4. Hold the surface element and drip bowl together as

level as possible and firmly push the terminal end into

the terminal plug. Moke sure element terminal is seated

properly into terminal plug. Make sure the surface

element is level to reduce the hazard of cookware

sliding off the element.

Important notes:

• Be sure the range is cool before removing surface

elements or drip bowls.

• Never immerse a surface element in water.

• Make sure drip bowls are in place - Absence of these

bowls during cooking may subject wiring or

components underneath to damage.

• Be careful not to bend terminal ends when replacing

surface elements after cleaning.

Fig. 1

Terminal plug

28