beautypg.com

Kenmore 146.1613311 User Manual

Page 23

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Sideburner

Loosen side burner in side shelf. (B). To loosen, unscrew and remove two front screws and washers

holding sideburner in place. (A). Note: Do not loosen electrode screw.

Remove knob and bezel from sideburner control valve. To remove, pull knob straight out from valve

stem. Unscrew bezel from valve face and set the two screws aside.

Insert valve stem through hole in fascia. (C) Attach bezel to fascia and valve face with previously

removed 2 screws. (D)

Place sideburner tube over the valve, making sure that valve is inside sideburner tube. (E)

Reattach sideburner to sideburner shelf with the 2 previously removed screws and washers. (G)

Push control knob onto sideburner valve stem. (F)

Replace sideburner grate. (G)

Insert the small tips of the four main control panel wires into four of the five module sockets. Insert the

small tip of the sideburner wire into the fifth socket. For the other wire with larger tips, attach the

two-wire tip to the module bare terminal. Attach the other tip to the terminal on top of the sideburner

control valve. (H)

Unscrew igniter cap from control panel. Insert (1) AA battery (not provided) into battery slot with

positive end (+) facing outward. Screw igniter cap back onto panel. (I)

J

16132-40200104

23

This manual is related to the following products: