Kenmore 721.358205 - Manual (Page 16)

TROUBLESHOOTING
Review this chart to find do-it-yourself solutions for a minor performance problems. Additional service
needed, other than those described in this owner's manual, should be performed at Sears Parts &
Repair Center.
WARNING
E lectrical shock and personal injury hazard.
D isconnect electrical supply before servicing or cleaning the unit. F ailure to
do so could result in electrical shock or personal injury.
P R O B LE M
CLEANER WILL
NOT RUN
P O S S IB LE C A U S E
2. Switch in off position.
3. Thermal protector activated
P O S S IB LE S O LU T IO N
1. Plug in firm'y, check circui: breaker, fuse.
2. Push switch to floor or carpet mode.
3. See "To correct problem", page 9.
1. Full or clogged dust bin. 1. Empty dust bin and clean the filters
2, Broken agitator belt. 2. Replace agitator belt.
POOR JOB OF 3. Clogged hose or nozzle. 3. Clean hose or nozzle area.
DIRT PICKUP
4. Hose not inserted fully 4. Insert hose
5. Worn agitator. 5. Replace agitator.
6. Hole in hose 6. Replace hose.
7. Dust bin assembly improperly
installed.
7. Properly install dust bin assembly
8. Belt not installed on motor shaft. 8. Install belt on the motor shaft
9. Motor protection system
activated.
9. Check for clogs
10. Agitator overload protector
activated
10. See "To correct problem", page 9.
DUST ESCAPES
THE DUST BIN
1. Dust bin assembly improperly
installed.
1. Properly install dust bin
LIGHT WILL NOT
WORK
1. Burned out light bulb. 1. Replace light bulb.
-16-