beautypg.com

Belt changing and agitator cleaning, Warning, Nozzle cover removal / installation – Kenmore 721.358205 User Manual

Page 13: To remove belt/ clean agitator

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

BELT CHANGING AND AGITATOR CLEANING

WARNING

E lectrical shock and personal injury

hazard.

D isconnect electrical supply before

servicing or cleaning the unit. F ailure

to do so could result in electrical

shock or personal injury from cleaner

suddenly starting.

Frequently check and remove hair, string, and

lint build-up in the agitator brush area. If build­

up becomes excessive, follovi/ the steps below.

Should the belt become loose or should it

break, follow the belt removal instructions.

NOZZLE COVER
REMOVAL / INSTALLATION

Disconnect electrical supply, press body

release pedal and rotate body down, so the

cleaner is laying flat on the floor.

To protect the floor surface place paper under

the nozzle and work area.

Remove 4 screws from the bottom as shown.

Turn cleaner upside down to take the cover off.

To replace the nozzle cover, hook the front of

the nozzle cover onto the nozzle base and turn

the cleaner upside down. Replace the 4 screws

on the bottom.

A

WARNING

P ersonal injury hazard

A lw ays unplug the vacuum cleaner

before cleaning the brush area as

agitator m ay suddenly restart. Failure

to do so can result in personal injury.

TO REMOVE BELT/

CLEAN AGITATOR

Position hands on opposite ends of the agitator.

If the belt is still attached to the agitator, there will

be tension on it.

Carefully lift the right end of the agitator and

then lift the other end.

Remove the worn or broken belt from the motor

drive shaft and clean the agitator.

-13-