Quick set-up, step 2, Connect your telephone as shown below – GE 2-9435 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
QUICK SET-UP, STEP 2
NOTE:
A coiled Handset Cord and a grey straight telephone cord are packed
in the carton. A second straight telephone cord (white) is located in
side the Wall/Desk Adapter.
Connect your telephone as shown below:
A. Plug one end of Handset cord into
Handset.
B. Plug opposite end into side of
telephone base.
C. If you have one 2-line jack:
• Plug the white telephone straight
cord into LINE 1 + 2 jack in Base.
Plug into Modular RJ14C (dual
line) jack (Fig. 1) . . .
— or —
If you have 2 single-line Jacks:
• Plug the grey telephone straight cord
into LINE 1 + 2. Plug the white
straight cord into LINE 2 jack in the
base. Then, plug opposite ends into
Modular RJ11C (single line) jacks
(Fig.
2
).
D. Set Ringer 1 and Ringer 2 switches
to “HI”.
• "LO” = sound will be lower.
• “OFF” = telephone will not ring.
E.
Set Mode Switch to “TONE”.
If dialing cannot be accomplished,
switch to “PULSE”.
You are now ready to try your new
telephone.
i
D
RINGER 2
D
RINGER 1
TELEPHONE
BASE
For further details, proceed to the following pages.