beautypg.com

System operation, Troubleshooting false alerts, Failure to alert – GE 45105 GE Drive Way Monitor User Manual

Page 2: Care and maintenance, Specifications, Â caution, Warning limitations of alarm products

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

keyhole slot over the screw and slide the unit into position

as shown in the figure on the right.

Powering the Indoor Alert Unit

1. Plug AC adapter jack into indoor alert unit.

2. Plug AC adapter into standard outlet.

3. Power indicator (RED) will turn on and unit will beep.

SYSTEM OPERATION

Each time the outdoor sensor detects a vehicle, the indoor alert
unit will beep and the visitor indicator (GREEN) will turn on. Press
the RESET button to return the unit to standby mode. The visitor
indicator will remain off until the sensor detects a new vehicle.

Use the knob on the side of the indoor alert unit to adjust the
volume to the desired setting.

The low battery indicator (RED) will turn on when the sensor

batteries need to be replaced. Refer to the

Installing Batteries

in Sensor

for detailed instructions on howto replace the batteries.

TROUBLESHOOTING

False Alerts

False alert may be caused by vehicles driving by on the street
Make sure the sensor is installed at least25ft from the street

The sensor may trigger a false alert on extremely windy days,

since the internal sensing coil will vibrate within a static magnetic
field. If the coil is stationary, a changing magnetic field triggers it
If the magnetic field is static, the coil triggers if it itself vibrates.

Failure to Alert

The sensorwill not trigger if it is placed too far from the driveway.
The detection radius needs to extend over the driveway.

Some compact vehicles are made of fiberglass (not metal). The
less metal in the vehicle, the harder it is for the sensor to trigger.

4

Check the outdoor sensor battery status often. If the low battery

indicator on the indoor alert unit turns on, make sure to replace the
batteries on the sensor as quickly as possible.

Make sure the sensor and indoor alert unit are as close to each other
as possible. The wireless range may be affected by heavy obstructions
or interference.

CARE AND MAINTENANCE

To clean the Driveway Monitor, use a soft cloth slightly dampened with

water, then wipe dry. Do not use chemical agents as this may damage

and discolor the Driveway Monitor.

SPECIFICATIONS

RFTransmission Frequency.................................. 433 MHz

RFTransmission Range.......................................... 400 ft*

Compact vehicle detection range
(100% accuracy at 20 mph)........................................ Oft

SUV or Van detection range
(100% accuracy at 20 mph)....................................... 12 ft

Power

Main Unit............... 12V DC/120V AC Power Supply (included)

Sensor......................................... 2 C Alkaline batteries

* Range is affected by many factors, including but not limited to:

walls and aluminum siding, obstacles between the sensor and

main unit, interference from remote controls, door chimes, and

weatherstations.

This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions:

1. This device may not cause harmful interference, and;

2. This device must accept any interference received, including

interference that may cause undesired operation.

5

CAUTION: Changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority to

operate the equipment.

NOTE: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.

The equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.

However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet in a circuit different from

that to which the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help

 CAUTION

Batteries may leak harmful liquids or ignitable
materials or explode causing injury and product
damage

• Do not mix old and new or other battery types

• Replace all batteries at the same time

• Replace fully discharged batteries immediately

6

WARNING

Limitations of Alarm Products

This product should be tested weekly to make sure it is working properly. The

product, if used properly, may reduce the risk of burglary, robbery, fire, or other
adverse events. However, JASCO is not an insurer, this product is neither
insurance nor a guarantee that such an event will be prevented, and users

should protect themselves with proper insurance. JASCO makes no

representation that this product cannot be compromised or circumvented, that
it will provide an adequate warning, or that it will prevent any personal injuries,
property damage, or other losses. Like any alarm product, including expensive
commercial systems, it may be bypassed, it is subject to compromise, and it
may fail to warn for a variety of reasons, including, but not limited to: improper
installation or positioning; improper maintenance; tampering; dead or
improperly installed batteries; sensing limitations; component failures; smoke
may not reach detectors; for wireless systems, the functional range may be
adversely affected by certain environmental conditions, radio frequency
interference and obstructions between the transmitters and receivers; for

systems using telephone lines, the lines may be out of service or disrupted; for

infrared products, intrusions may be outside of a products designed range
and certain environmental conditions may impact performance and audible
alarm signals may be outside of hearing range, muted by doors, walls, and

floors, unheard by deep sleepers or the hearing-impaired, or overwhelmed by

other sounds.

90 DAY LIMITED WARRANTY: Jasco Products Company warrants this product

to be free from manufacturing defects for a period of ninety days from the

original date of consumer purchase. This warranty is limited to the repair or

replacement of this product only and does not extend to consequential or

incidental damage to other products that may be used with this unit. This

warranty is in lieu of all other warranties express or implied. Some states do

not allow limitations on how long an implied warranty lasts or permit the
exclusion or limitation of incidental or consequential damages, so the above
limitations may not apply to you. This warranty gives you specific rights, and

you may also have other rights which vary from state to state. If unit should
prove defective within the warranty period, return prepaid with dated proof of
purchase to:

Jasco Products Company

311 N.W. 122nd

Oklahoma City, OK. 73114

45108 1/3/05