Selecting a cycle, Heat dry or air dry, To add a dish after starting – Whirlpool DP3000XR Series User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CYCLE CONTROL KNOB
Selecting a cycle
NORMAL WASH Cycle
A double wash for normal to heav
ily soiled loads. (The Energy Guide
Label data is based on this cycle.)
Cycle time is about 65 minutes.
W
A
S
H
W
A
S
H
N
S
E
R
I
N
S
E
D
R
Y
O
F
LIGHT WASH Cycle
For normal, everyday soiled lodds.
Cycle time is about 60 minutes.
R
1
W
R
1
R
1
D
O
N
S
E
>
A
S
H
>
N
S
E
>
N
S
E
1
R
1
F
RINSE & HOLD Cycle
For rinsing a few items to be washed
one or more days later. Cycle time
is about
t o
minutes.
Use AIR DRY only.
R
R
1
1
O
N
m
N
F
S
w
S
F
E
E
HEAT DRY or AIR DRY?
If the
HEAT DRY Option
is selected, air in the
dishwasher is heated during the "dry" part of
the cycle.
If the
AIR DRY Option
is selected, air in the
dishwasher is not heated. Using this option helps
save energy, but dishes take longer to dry (over
night) and some water spotting may result.
Some items (such as plastics) may need towel
drying.
For best results, use a solid rinse aid.
To add a dish after starting
1. To be sure the added item is washed and
rinsed, make sure the Cycle Control Knob
has not passed LIGHT.
2.
Lift up on the door latch to unlatch the door
and to stop the cycle. Don’t open the door
until the spray arms stop spinning.
3.
Open the door and add the dish.
4.
Close the door.
Do not latch it.
Wait 30 sec
onds for air in the dishwasher to warm up. This
helps reduce the amount of moisture that
can come from the vent when restarting the
cycle.
5.
Press door firmly to latch it. The dishwasher
will automatically start where it stopped.