Light wash cycle, Normal wash cycle, Rinse & hold cycle – Whirlpool DP3000XR Series User Manual
Page 8: Changing a setting, Starting your dishwasher
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ULUUUUUUUUUUUUUULLLUUI
Before starting
your dishwasher
1. Read "Important Safety Instructions” on page
2 before starting your dishwasher.
2.
Spin the Upper and Lower Spray Arms to
make sure nothing will stop them from turning
freely.
Starting your dishwasher
DRY SELECTOR SWITCH
3.
Push door firmly when closing and it will auto
matically latch.
4.
Run hot water at sink nearest dishwasher until
it is hot. Turn it off. See page 14 for connecfing
instructions.
LIGHT WASH Cycle...
1. Select a drying option.
2. Turn Cycie Controi Knob clockwise
to dot marked LIGHT. The dishwasher
will automatically start that cycle.
NORMAL WASH Cycle...
1. Select a drying option.
2. Turn Cycle Control Knob clockwise to
dot marked NORMAL. The dishwasher
wiil automaticaiiy start that cycie.
RINSE & HOLD Cycle...
1. Select AIR DRY OPTION only.
2. Turn Cycle Control Knob clockwise
to dot marked RINSE & HOLD. The dish-
v/asher will automatically start that
cycle.
Changing a setting
You can change a setting anytime during any
cycle.
1.
Lift up on the door latch to unlatch the door
and stop the cycle. Don't open the door until
the spray arms stop spinning.
2.
Turn the Cycle Control Knob clockwise to the
cycle you want.
3.
Be sure the detergent dispensers are filled
properly for the new cycle.
4.
Press door firmly to latch it. The dishwasher
will automatically start the new cycle.
8