Compaq iPAQ H3000 - Manual (Page 116)

c-4 Regulatory Notices
Power Cords
If you were not provided with a power cord for your iPAQ 3000 Pocket PC or for an AC
power accessory intended for use with your device, you should purchase a power cord that
is approved for use in your country.
The power cord must be rated for the product and for the voltage and current marked on
the product’s electrical ratings label. The voltage and current rating of the cord should be
greater than the voltage and current rating marked on the product. In addition, the diame-
ter of the wire must be a minimum of 0.75 mm
2 /18AWG, and the length of the cord must
be between 5 feet (1.5 m) and 6.5 feet (2 m). If you have questions about the type of power
cord to use, contact your Compaq authorized service provider.
A power cord should be routed so that it is not likely to be walked on or pinched by items
placed upon it or against it. Particular attention should be paid to the plug, electrical outlet,
and the point where the cord exits from the product.
To reduce the risk of personal injury, electric shock, fire, or damage to the equip-
ment:
• Do not disable the power cord grounding plug. The grounding plug is an impor-
tant safety feature.
• Plug the equipment into a grounded (earthed) electrical outlet that is easily
accessible at all times.
• Disconnect power from the equipment by unplugging the power cord from the
electrical outlet.
• Do not place anything on power cords or cables. Arrange them so that no one
may accidentally step on or trip over them.
• Do not pull on a cord or cable. When unplugging from the electrical outlet,
grasp the cord by the plug.
!