Using the air swing feature, Modifying the temperature, Modifying the fan speed – Whirlpool 3PACH21DD0 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

OPERATING YOWVAMliOOimTIOH

Modifying the temperature

Although the AUTO COOL Cycle has an
initial factory-preset cooling temperature,
you may decide the room is too cool or too
warm. When you change the temperature
from the factory-preset, the air conditioner

uses fuzzy logic (computerized “learning”) to
remember your preferences. Over time, the
unit “learns” exactly what conditions make

you most comfortable.

To modify the temperature:

• Press the WARMER Button to raise the

temperature of the outgoing air.

,/WARME^

• Press the COOLER Button to lower the

temperature of the incoming air.

NOTE:

Each press alters the temperature

approximately 1 °C.

\COOLE^

Modifying the fan speed

Although the AUTO COOL Cycle automati
cally chooses the proper fan speed to cool
the room, you may desire to increase or
decrease the amount of air blowing into the

room.

To modify the fan speed:

• Press the FAN SPEED Button.

NOTE:

Each press of the FAN SPEED

Button advances the fan speed through

the cycle:

HI MED -► LOW HI

FAN SPEED

<_______________ >

Using the AIR SWING feature

The AIR SWING feature tells your air
conditioner to move the air output louvers
side-to-side and swing the cooled air
through the room.

To activate the AIR SWING feature:

• Press the AIR SWING Button.

To deactivate the AIR SWING feature:

• Press the AIR SWING Button again.