Whirlpool 3PACH21DD0 - Manual (Page 6)

OPERATING YOUR AIR CONDITIONER
Operating Your Air
Conditioner
In This Section
Page Page
Using the AUTO COOL Cycle.... .......... 6 Using the SLEEP HOURS Cycle.. .......10
Modifying the temperature............... .......... 7 Using the TIMED OFF
Modifying the fan speed................... .......... 7
HOURS Cycle......................................... .......11
Using the AIR SWING feature ... .......... 7
Using the CHECK FILTER light.... ....... 11
Turning the unit off........................... ........... 8
Modifying the air direction.................. .......12
Using the HEAT ONLY Cycle .... ........... 8
Using the exhaust door....................... ....... 12
Using the DRY ONLY Cycle.............. ........... 9
Using the remote control..................... ....... 12
Operating your air conditioner properly is
essential to obtain the best possible results.
This section tells you about each cycle and
how to operate it.
IMPORTANT: After turning the unit off, wait
approximately 3 minutes before turning it
back on. If you don’t wait approximately
3 minutes, the air conditioner will try to start,
but turn itself off until the compressor is
ready to start again.
DO NOT disconnect the air conditioner
from its electrical supply. DO NOT use
an electrical outlet that can be turned
off with a switch. When the air condi­
tioner is disconnected from its electrical
supply (including power outages) all
programming reverts back to the
factory-preset information. However,
the air conditioner will “relearn” your
preferences.
Using the AUTO COOL
(Single-Button Cooling)
The AUTO COOL Cycle is designed to
provide you with the comfort you desire by
continually “learning” your preferences.
Once the Cycle “learns” what temperature(s)
you desire, it automatically chooses a fan
speed when turned on and cools the room
as quickly as possible.
NOTE: You can modify the fan speed and
temperature when using the AUTO COOL
Cycle, if desired. See “Modifying the fan
speed” or “Modifying the temperature” on
page 7.
To activate the AUTO COOL Cycle:
• Press the AUTO COOL/ON Button.
NOTE: When the cycle is active, the
indicator light on the AUTO COOL/ON
Button will be lit.
Cycle
AUTO COOL BURST
AUTO COOL BURST cools the room for
15 minutes before allowing the room to rise
to your prelearned temperature. This cycle is
especially useful if you are hot from exercise
or it is very hot in the room.
To activate AUTO COOL BURST:
• Press the AUTO COOL/ON Button twice.
\lx
r
AUTO
7T^ N
ro COOL
ON j