Whirlpool FES310B - Manual (Page 30)

I F Y O U N E E D A S S I S T A N C E O R S E R V I C E
PROBLEM POSSIBLE CAUSE SOLUTION
Control knob(s)
will not turn You are not pushing in
before trying to turn. Push control knob(s) in before turning to
a setting.
Self-Cleaning
cycie will not
operate The Oven Selector and
Oven Temperature Control
Knob are not set to CLEAN.
Set both the Oven Selector and Oven
Temperature Control Knob to CLEAN.
The range clock does not
show the correct time
of day. Reset clock to show the con-ect time of
day. (See page 11.)
The Lock Lever is not in
the CLEAN position - all
the way to the right. Move the Lock Lever all the way to
the right.
The Start Time Knob does
not show the correct time
of day or the knob is not all
the way out.
Reset the Start Time Knob to show the
correct time of day. Pull knob out all
the way.
The Stop Time Knob is not
set ahead to the time you
want the Self-Cleaning
cycle to stop. See Step 3 in “Setting the controls” on
page 22 for proper setting instructions.
Cooking
results are not The range is not level. Level range. (See Installation Instruc­
tions.)
what you
expected
The oven temperature
seems too low or too high. Adjust the oven temperature control.
(See “Adjusting the oven temperature
contror on page 13.)
The oven was not pre­
heated as the recipe
calls for.
Preheat oven if called for in recipe.
The recipe has never been
tested or is not from a
reliable source.
Use only tested recipes from a reliable
source.
The pan used is not the
type or size recommended
in the recipe.
Refer to a reliable cookbook for recom­
mended pan type and size.
There is not proper air
circulation around pan
when baking. Allow 1V 2 to 2 inches (4-5 cm) on all
sides of the pans for air circulation.
There must be a minimum space of
1 inch (3 cm).
The cooking utensils are
not the proper shape or do
not fit the surface units
being used.
Use cooking utensils with snnooth, flat
bottoms that fit the surface units
being used.
30