Whirlpool FES310B - Manual (Page 21)

Using the Self-Cleaning
Cycle
In This Section
Page Page
How the cycle works...............
...........21 Setting the controls..............
........... 22
Before you start......................
...........21 Special tips........................... .............. 23
The Self-Cleaning cycle saves you from the toil and mess that often come with hand-cleaning
the oven interior. Like the other functions of your range, you operate the Self-Cleaning cycle
with the easy-to-use controls. Please review the instructions in this section to keep your oven
spotless.
How the cycle works
The Self-Cleaning cycle uses very high heat
to burn away soil arid grease. During the
cycle, the oven gets much hotter than it
does for normal baking or broiling. This high
heat breaks up the soil or grease and burns
it away.
You can adjust the cycle time to the amount
of soil in your oven. You can set the cycle
time anywhere between 2 and 4 hours. (See
“Setting the controls” on page 22.)
The graph at the right is representative of
a normal, 3-hour Self-Cleaning cycle. Note
that the heating stops when the 3-hour
setting is up, but it takes longer for the oven
to cool enough to unlock.
START 1 2
Tima In Hours
STOP
Before you start
Before you start the Self-Cleaning cycle,
make sure you:
• Hand-clean the areas shown.
They do
not get hot enough during the cleaning
cycle for soil to bum away. Use hot water
and detergent or a soapy steel-wool pad
for cleaning.
NOTE: DO NOT clean, move, or bend the
seal. Poor cleaning, baking, and roasting
may result.
21