Whirlpool System I User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Instructions At A Glance • For detailed instructions see following page.
1. Turn off cold water supply. (Steps 1a-1b)
! WARNING
Electrical Shock Hazard
Special care must be taken when drilling into
water pipes. Some water may remain in water
supply pipe:
• If an electric drill is used, it must be properly
grounded to prevent severe or lethal shock if
water should enter drill.
• Use only an electric drill that is double
insulated or properly grounded.
• Check with qualified electrician if you are in
doubt as to whether your electric drill is
properly grounded.
• Only drill at top or side of horizontal water
supply pipe. DO NOT drill at bottom of
horizontal pipe where water may remain.
Failure to follow these instructions could result
in personal injury or death.
2. Turn on faucet to drain water from line.
(Step 1b)
w
3. Connect saddle valve to cold water supply. Turn saddle
valve handle clockwise until piercing lance enters
pipe and stops. (Steps Ic-lg or Ih-lj)
4. Connect one end of orange tubing to saddle valve.
Connect other end to filtration assembly. (Step Ik)