beautypg.com

Installation overview, Before you start – Whirlpool System I User Manual

Page 3

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Installation Overview

Before You Start...

IMPORTANT : Read and save these instructions.
It is recommended that this system be installed by a licensed plumber.
It is the responsibility of the installer to comply with the
installation specifications provided and with state and local
plumbing codes.

If you decided to install the system yourself, see “General
Information” on page 9 before continuing.

Water Filtration Systems I, II and III can be installed in the basement if
there is not adequate room for under-sink installation. Order additional
tubing, Part No. 4319151 from your Whirlpool dealer.

If you need assistance...

Refer to the Use & Care information at the end of this booklet. If you need more help,

the Whirlpool Consumer Assistance Center will answer any questions you may have
about operating or maintaining your water filtration system. The Whirlpool Consumer
Assistance Center is open 24 hours a day, 7 days
a week. Just dial 1-800-253-1301—the call is free.
When you call, you will need the water filtration
system model number and serial number. Both
numbers can be found labeled on the filtration
assembly.

(5

HOOK UP WATER

»Turn off cold water supply.
•Turn on faucet to drain water from line.

Connect saddle valve to cold water supply.

Turn saddle valve handle clockwise until
piercing lance enters pipe and stops.

Connect one end of orange tubing to

saddle valve. Connect other end to

filtration assembly.

(^ SYSTEM CONNECTION

Decide if the system will be connected

to your refrigerator, to an optional faucet
or to both.

• Connect refrigerator’s water supply to

filtration assembly with blue tubing.

• Or, install faucet in sink and connect

blue tubing to filtration assembly.

• Or, use "T” grey connector to connect

both refrigerator and faucet.

I START UP

• Slide filtration assembly onto mounting

screws.

• Turn on cold water supply.
• If filtration assembly was connected to

refrigerator, make and discard 2 batches
of ice and drain 2-3 gallons of water from
water dispenser.

• If filtration assembly was connected to

sink faucet, lift faucet handle to discard
2-3 gallons of water.

This manual is related to the following products: