Performance data sheet, Whirlpool water filtration system, Systems i, ii – Whirlpool System I User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
This product has been tested and listed by NSF International under Standard 42
® ] for Taste, Odor and Chlorine reduction (Class I) and Particulate reduction (Class
II) and under Standard 53 for Cyst, Turbidity, Lead and VOC reduction.
Whirlpool Water Filtration System
SPECIFICATIONS: Lead, VOC and Taste/Odor/Chlorine reduction (Class I) CAPACITY: 500 Gallons
SERVICE FLOW RATE: 0.6 GPM (2.2 Umin) @ 60 psi ^
Performance Data Sheet
Systems I, II &
General
Performance
Average
Influent
Maximum
Effluent
Mlnlmum%
Reduction
NSF Test
Requirement
Chlorine'
2.0 mg/L
<0.1 mg/L
92%
minimum75%
reduction (Clas^ 1)
Particulate
560,000 part/mL^ 18,000 part/mL
98%
minimlim 85%
reduction (Class II)
Cyst
215,000 4-6n/mL3 390 4-6 ti/mL
99.9%
minimum 99.9%
reduction
Turbidity
14NTU
0.42 NTU
97%
minimum effluent
1.0 NTU
Contaminant
Reduction
Performance"
U.S. EPA
MCL
Average
infiuent
Maximum
Effluent
Minimum%
Reduction
NSF Test
Requirement
Lead @ pH 6.50.015 mg/L 0.16 mg/L5 0.005 mg/L
97%
maximum effluent
0.015 mg/L
Lead @ pH 6.5 0.015 mg/L 0.17 mg/L® 0.002 mg/L
99%
maximum effluent
0.015 mg/L
'Free Available Chlorine.
^est requirement is at least 10,000 Partides/mL of AC Fine Test Dust.
^esl requirement is 4-6 micrometer size particles per mL of influent.
^These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
^Tes
1
requirement 0.15 mg/L± 15%.
VOLATILE ORGANIC CHEMICAL REDUCTION
This system has met the testing requirements of Standard 53, Section 5.1.1 for the
reduction of chloroform, which is the surrogate for the foliowing chemicals
Maximum
Influent
Minimum
Occurrence
Effluent
Concentration Percent
Chemical Levels (ppb)
Level (ppb) Other VOC’s’
(ppb)
Reduction
Benzene 30'
5®
cis-1,3-Dichloropropene 80
95%
Carbon Tetrachloride 40'
5®
Chlorobenzene
80
95%
p-Dichlorobenzene 80®
5"
Hexachlorobutadiene
40
95%
Trichloroethylene 300'
5®
ortho-Xylene
80
95%
Trihalomethanes 300
15
trans-1,2-Dichloroethene 80
95%
(surrogate chemical)
1,1,2,2-Tetrachloroethane80
95%
1,1 -Dichloroethylene 50'
7®
1,2-Dichlorobenzene
80
95%
1,1,1 -T richloroethane 80®
5"
1,2-Dichloroethane
80
95%
1,2-Dichloroethane 100'
5®
Ethylbenzene 80®
4"
Tetrachloroethylene 80®
4"
Toluene 80®
4"
1,2-Dichloropropane 80®
5®
'Influent levels are the 95th percentile, cxxurrence levels are per Federal Register, Vol. 50, No. 219, November 13,1965, p
46917.
^Since the 95th percentile occurrence levels were too low and thus were not pertinent for testing these chemicals against their MCL’s,
a reasonable level was selected for surrogate testing as shown.
^EPA Primary Maximum Contaminant Levels
^Maximum effluent concentrations set at the practical quantitation level (POL) which is less than the MCL.
^In the absence of officially stated occurrence levels and MCL’s, the surrogate influents were selected to provide a reasonable test.
APPLICATION GUIDELINES/WATER SUPPLY PARAMETERS
Water supply - community or private well
Potable (suitable for drinking)
Water Pressure
30-100 psi (207 - 690kPa)
Water Temperature
40° - 100°F (4.4° - 38°C)
pH Range
6-9
Maximum TDS Level
500 ppm
Dissolved Iron
< 0.1 ppm
Dissolved Manganese
< 0.05 ppm
Turbidity
< 1 NTU
Water supplies that exceed limits for iron or manganese require (xetreatment.
It is essential that operational, maintenance and filter replacement requirements be carried out for the product to perform
as adv^ised.
CAUTION: Do Not use where water is microbiologically unsafe or wKh water of unknown quality without adequate
disinfection before or after the unit.
WARRANTY
Length of Warranty:
Whirlpool will pay for:
One Year Full Warranty
(From date of purchase)
Replacement parts and repair labor to correct defects
in materiais or workmanship for the entire product
except for the filter cartridge(s). Service must be
provided by an authorized Whirlpool servicing outlet.
Five Year Limited Warranty
(Second through fifth year
from date of purchase)
Replacement parts to correct defects in materials or
workmanship for the entire product except for the
filter cartridge(s).
Whirlpool will not pay for:
A. Service calls to:
1.
) Correct the installation of the product. System must be installed and operated in accor
dance with Whirlpool procedures and guidelines.
2.
) Instruct you how to use the product.
3.
) Correct house plumbing.
B. Repairs when product is used in other than normal, single-family household use.
C. Repairs when product Is damaged from neglect, misuse, abuse, freezing or hot water, fouling
with sediment or scale, bacterial attack, alterations, improper installation, or installation not in
accordance with local plumbing codes.
D. Any labor costs during the limited warranty.
E. Replacement parts or repair labor costs for units operated outside the U.S.
F. Pickup and delivery. This product is designed to be repaired in the home.
G. Repairs to parts or systems caused by unauthorized modifications made to the product.
The performance and functioning of your water filtration system is directly related to the quality of
the water being treated and the particular application in which it Is used. Please consult "Water
Requirements” and “Use & Care”.
Whiripool shall not be liable for Incidental or consequential damages. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so this limitation or exclusion may
not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
13