Setting the controls, Warning – Whirlpool RB260PXY User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

U S I N G T H E S E L F - C L E A N I N G C Y C L E
2. Remove the broiler pan grid and any pots and
pans being stored in the oven.
NOTE: The broiler pan (without grid) can be
cleaned in the oven if most of the soil is
removed first by hand
excessive smoking will occur. The chrome
broiler pan grid will discolor if cleaned in the
Self-Cleaning cycle.
3. Wipe out any loose soil or grease. This will
help reduce smoke during the cleaning cycle.
4. Remove the oven racks from the oven if you
want them to remain shiny. If the oven racks
are cleaned in the Self-Cleaning cycle, place
them on the 2nd and 4th rack guides. (Guides
are counted from bottom to top.)
NOTE: If oven racks are cleaned in the Self
Cleaning cycle, they will become harder to
slide.
Heat and odors are normal during the Self
Cleaning cycle. If needed, remove them by
opening a window or by turning on a vent hood
or other kitchen vent during the cycle.
^WARNING
Personal Injury and
Product Damage Hazard
• Do not touch the oven during the Self
Cleaning cycle. It could bum you.
• Do not use commercial oven cleaners in
your oven. Cleaners may produce hazard
ous fumes or damage the porcelain finish.
• Do not leave foil in the oven during the Self
Cleaning cycle. Foil can burn or melt and
damage the oven surface.
NOTE: Do not force the Lock Lever. You could
bend or break it. The lever is designed to stay
locked until the oven is cool enough to safely
open. Wait until it moves freely.
Do not block the vent during the Self-Cleaning
cycle. Air must move freely for best cleaning
resuhs.
Do not leave plastic utensils near the vent.
They may mek.
Setting the controls
1. Make sure the clock is set to the correct time
of day. (See “Setting the clock" on page 10.)
2. Lift the panel between the oven door and the
control panel. Move the Lock Lever all the way
to the righMhe Clean position.
3. To start cleaning immediately:
Push the Clean pad. A 3-hour Self-Cleaning
cycle will be set automatically. “3:00” with the
colon flashing will show in the large display
and “cin” will show in the small display. TIME,
CLEAN (on right side) and CLEAN (on left
side) will light up.
29