beautypg.com

Before using your refrigerator, Removing packaging materials, Cleaning it before use – Whirlpool 3ET22DKXDN00 User Manual

Page 6: Cleaning your refrigerator, Plugging it in

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Before Using Your
Refrigerator

It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it, and level it.

Cleaning your refrigerator

Removing packaging materials

Remove tape and any inside labels (except

the model and serial number label) before
using the refrigerator.

To remove any remaining tape or label
glue:
• Rub briskly with thumb.
OR
• Apply liquid hand-dishwashing detergent to

area before removing glue as described
above. Do not use sharp instruments, rub­
bing alcohol, flammable fluids, or abrasive
cleaners. These can damage the material.

See “Important Safety Instructions” on
page 3.

NOTE: Do not remove any permanent
instruction labels inside your refrigerator. Do
not remove the Tech Sheet fastened under

the refrigerator at the front.

Cleaning it before use

After removing all packaging materials, clean

your refrigerator before using

it, if necessary. See cleaning
instructions on page 17.

Plugging it in

Recommended Grounding Method

A 115 Volt/60 Hz (Plug 1), 220/240 Volt/50

Hz (Plug 2), 220 Volt/60 Hz or 220/240 Volt/

50 Hz (Plug 3) AC only 15 or 20 ampere
fused and properly grounded electrical
supply is required. It is recommended that a
separate circuit serving only this appliance
be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do
not use an extension cord.

Ai

rsn

Bj

vgy

k '—14

Plug 1

Plug 2