Whirlpool 3ET22DKXDN00 - Manual (Page 13)

Removing the crispers and crisper cover
To remove the crispers:
1. Slide crisper straight out to the stop.
2. Lift the front and slide out the rest of
the way.
3. Replace in reverse order.
To remove the cover:
1. Push up the glass insert from the bottom,
then slide out with both hands.
2. Lift front of cover frame.
3. Lift cover frame up and out.
To replace the cover:
1. Fit back of cover frame into notch sup­
ports on back wall of refrigerator, then
lower the front into place.
2. Make sure the front cover metal support
is in the notches in the sides of the liner.
NOTE: If the support is not positioned
properly, the doors may not close all
the way.
3. Slide back of glass insert into place, then
lower front.
Pull out to the
stop, lift the front,
and pull again.
Remove the glass
Insert. Lift the
cover front, then
the back.
NOTE: Glass Insert
Is heavy. Handle it
carefully.
Adjusting the half-width freezer shelf
Adjust the shelf according to the space you
need in your freezer. Use the bottom posi­
tion when you don’t need the shelf at all.
To adjust the shelf:
1. Remove items from the shelf.
2. Lift shelf up at front.
3. Pull shelf out to the stop.
4. Lift back of shelf.
5. Pull shelf out the rest of the way.
To replace the shelf:
1. Guide rear of shelf into desired guide.
2. Lift rear of shelf over stop.
3. Slide shelf in all the way.
4. Lower front into place.
12