Carl Goldberg GBGP0105 - Manual (Page 5)

5
4.† Install the lower drawer shelf(1/8”x10-3/4”x12-
5/8”) by sliding into the dado slots in the right
upright and the drawer divider. Make sure it goes
into the slots on the back panel.
5.† Install the other two drawer shelves in the same
manner. (1/8”x10-3/4”x12-5/8”)
6.† Install the small drawer shelf (1/8”x10-3/4”x3-
7/8”) between the left upright and the drawer divider
in the same manner.
8. † Install the top shelf into the dado slots on each
upright. (1/8”x10-1/2”x16-5/8”)
9. † Install the front panel. Fit into dado slots along
the bottom and each upright.
10. † Install the battery panel divider in the dado
slot in the floor. Make sure it is vertical so the power
panel will fit.
Make sure the distance is
the same at both ends.
(7-1/8”)