Carl Goldberg GBGA1072 - Manual (Page 9)

Trial fit the gear mounting
plate in the nose of the fuselage. It
should be flush with the bottom of
the fuselage and snug with the
former. You may have to sand the
edges slightly for a good fit.
When you are satisfied with the
fit, epoxy in place with 5-minute
epoxy.
When the epoxy is dry, tack the
landing gear in place with medium
CA glue.
Next trial fit the filler plate.
Again slight sanding may be needed
for a snug fit. When you are satisfied
with the fit, epoxy in place with 5-
minute epoxy.
Next trial fit the cover plate. A
little sanding of the edges may be
needed for a good fit. Epoxy in place
with 5-minute epoxy, using the
epoxy to fill in any gaps between the
landing gear and the mounting
plates. Set the assembly aside until it
is dry.
Next locate the two main
wheels and four wheel collars. Install
the wheels onto the main gear, using
9