Carl Goldberg GBGA1072 User Manual

Page 14

Mount your 1/2A motor on the

firewall, using the laser-etched lines
as a guide. You will need 4 #2 x 3/8”
wood screws (not supplied).

Remove the motor from the

firewall and epoxy the firewall to the
front bulkhead using 5-minute
epoxy.

When the 5-minute epoxy has

cured, coat the entire engine
compartment with 30 minute epoxy
to fuel proof the bare wood.

Now re-mount the motor to the

firewall and make sure the prop will
clear the nose of the airplane.