Carl Goldberg GBGA1072 - Manual (Page 8)

Next, install the rudder using
the method described above. Make
sure the elevator does not bind on the
rudder before you glue the hinges.
Remove a ¼” triangle from the
rear of the stab platform, just like
you did the bottom of the fin.
Now CA the rudder hinges on
both sides. The tail section is now
finished.
Fuselage Construction
(Note, your kit may differ slightly
from the prototype from which this
manual was written. Your pieces
may already be assembled, in which
case you only need to glue the gear
to the pre-assembled plate and epoxy
it to the firewall.)
Locate the wood landing gear
mounting pieces and the wire
landing gear.
8