Carl Goldberg GPMA1960 Gentle Lady Glider ARF - Manual (Page 7)

7
bit. Thread a servo mounting screw (included with the servo)
into each hole then remove it. Remove the servos and apply
a drop of thin CA to each hole to harden the wood. When
the CA has hardened, install the servos using the hardware
included with the servos.
4. Trim the covering from the rudder and elevator pushrod
exit slots.
5. Thread a nylon clevis onto a 31-1/2” [800mm] pushrod
20 complete turns. Slide a silicone clevis retainer over the
clevis. Temporarily attach the clevis to the second inner hole
of a control horn (separate the control horn backplate from
the control horn).
CORRECT INCORRECT
6. Insert the rudder pushrod into the rudder outer pushrod
tube from the aft end. Align the holes in the control horn over
the rudder hinge line and mark the locations of the control
horn mounting holes onto the rudder. Drill two 5/64" [2mm]
holes at the marks on the rudder. Apply a drop of thin CA into
each hole to harden the balsa.
7. Install the control horn using two 2x10mm machine
screws and the control horn backplate.