Carl Goldberg GBGA1078 - Manual (Page 9)

9
Install the gear on the fuselage
using the two 3mmx30mm bolts, four
3mm flat washer, and two 3mm lock
nuts.
Locate the elevator joiner wire and
the two elevator halves. Measure the
width of the stab and lay the eleva-
tors spread to that length. Mark the
location of the holes for the eleva-
tor joiner wire on the stab.
width of stab
Drill a 1/8” hole at the location of
the mark and notch the leading edge
of the stab so the wire will be flush
with the leading edge. Repeat for the
other elevator half.
Install the axle in the aluminum gear
and secure with a 8mm flat washer
and lock nut. Install one of the
wheel collars, the main wheel and
secure on the outside with the other
wheel collar.