Carl Goldberg GBGA1078 - Manual (Page 10)

10
Glue the joiner wire in place with
epoxy. Make sure the elevators are
lying on a flat surface so both will
be parallel. Use a straight edge to
make sure the leading edge is
straight and the tips are at the prop-
er width.
Fit the elevators in place on the CA
hinges.
Deflect the elevator to full travel
and glue hinges with two drops of
thin CA on each hinge. Turn over and
repeat on bottom side.
Fit the rudder in place on the fin and
mark the location of the elevator
wire.
elevator wire
Go to the bottom of the rudder and
mark the location of the tail wheel
tiller arm.
tail wheel
tiller arm