Carl Goldberg GBGA1078 User Manual
Page 17
17
Mount the throttle servo using the
hardware supplied with the radio.
Use the1.5 mm x 6”pushrod and bend
a z bend in one end and attach to the
throttle arm on motor. Attach the e-
z connector to a three hole servo
arm and attach to servo.
Make a small hole on the bottom of
the wing on the left side to pass the
throttle servo lead into the wing.
You will need an extension to get to
the receiver.
Install the proper prop for the
engine you have chosen and a 2-1/4”
spinner. Set the control throws to
3/8” both directions on low rate and
all you can get on high. On high rate
use 60 percent exponential. Be sure
to use the proper plus or minus
depending on the radio system used.
This airplane is very sensitive on high
rate so be ready for it.
Locate the two hatch access doors.
Drill a 3/32” hole in all four cor-
ners of each hatch. Space the holes
off each side 3/32”.
After all wires are plugged into
receiver and battery pack install the
covers by drilling a 1/16” pilot hole
through the hole in the cover and
attach using the four 2.5mm x 8mm
washer head screws.