CAMCORP HVP with Roots Blower - Manual (Page 10)

4-2
CAMCORP, INC.
Phone: 913-831-0740 Fax: 913-831-9271
ON SITE STORAGE RECOMMENDATIONS (continued)
IV. Fan and Fan Accessories
1. Fans can be stored outside on a pallet or skid to keep out of water and dirt.
2. Equipment should be covered with a tarp to protect from the bags.
3. Fan silencers, outlet dampers, and inlet boxes should also be tarped and stored
on a pallet or skid.
V. Ducting
1. Ducting can be stored outside on a pallet or skid to keep it off the ground. It
should be positioned so that water does not sit in the equipment.
2. If ducting is unpainted steel, it should be at least primed coated before storage.
3. If ducting is already finish coated, it should be tarped to protect the finish but is
not absolutely necessary.
VI. Knife Gate
1. All limit switches, solenoids, and air cylinder ports must be capped and taped to
prevent any moisture or dirt from entering.
2. Equipment can sit outside provided it is covered with a tarp and is on a pallet or
skid to keep it out of the water and dirt.
VII. Isolation Dampers
1. All limit switches, solenoids, and air cylinder ports must be capped and taped to
prevent any moisture or dirt from entering.
2. Equipment can sit outside provided it is covered with a tarp and is on a pallet or
skid to keep it out of the water and dirt.
VIII. Rotary Valve
1. Rotor and interior of valve should be well oiled with vegetable oil to prevent
rust and to maintain compatibility with product.
2. Unit can be stored outside provided it is covered with a tarp and is on a pallet or
skid to keep it out of the water and dirt.