Char-Broil AMERICAN GOURMET 10301580 - Manual (Page 12)

9
10
Page 12
Hinge Pin
Hair Pin Clip
Hinge Pin
Handle with
Barrel Spring
1/4-20x1/2
Screws
Install the Swing-Away Grate by inserting 2 each 1/4-20x2" screws (one for each side of the lid) into Grill Lid and s
Place the wire loop in Swing-Away over the shaft of the bolt, as shown below.
Similarly secure the Swing-Away leg to the firebox using 2 each 1/4-20x3/4" screws and 2 each 1/4-20 flange nuts.
ecure
with 2 each 1/4-20 flange nuts.
1/4-20
Flange Nut
Damper Wheel
Flat Washer
1/4-20
Flange Nut
1/4-20x 3/4 Screw
Flat
Washer
Attach the butterfly damper wheel to the firebox using 1 each
1/4-20x3/4" screw, 2 each flat washers, 1 lock washer and
one 1/4-20 flange nut. DO NOT FULLY TIGHTEN THE
FLANGE NUT. This will allow for rotation of the damper wheel.
1/4-20x2"
Screw
1/4-20x3/4"
Screw
1/4-20 Flange Nuts
Hinge Properly Installed
Lock Washer
Swing-
Away Leg
Wire Loop
Lock Washer
Place Grill Lid on top of firebox assembly. Align hinge holes on back of unit. With the aid of a helper, attach Grill
Lid to firebox using 2 each Hinge Pins. Once Hinge Pins are in place, insert Large Hair Pin Clip into hole in
Hinge Pin.
Next, install Smokestack by inserting 2 each 1/4-20x3/4 screws though Grill Lid, insert Smokestack into Grill Lid
hole, then secure using 2 each 1/4-20 flange nuts.
Attach Handle to Grill Lid, secure with 2 each 1/4-20 Flange nuts and 2 lock washers.