Chicago Electric MULTI-FUNCTION POWER TOOL 67256 - Manual (Page 10)

SKU 67256 For technical questions, please call 1-800-444-3353. Page 10
OPERaTINg INSTRUCTIONS
Read the ENTIRE IMPORTaNT
SaFETY INFORMaTION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Work Piece and Work area Set Up
Designate a work area that is clean 1.
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Route the Power Cord (46) along a
2.
safe route to reach the work area
without creating a tripping hazard or
exposing the Power Cord to possible
damage. The Power Cord must
reach the work area with enough
extra length to allow free movement
while working.
Secure loose work pieces using
3.
a vise or clamps (not included) to
prevent movement while working.
general Operating Instructions
With the tool unplugged, mount the 1.
desired attachment in place.
Pull the Power Switch (44) back to
2.
its off position. Then plug the Power
Cord (46) into the nearest 120 volt,
grounded electrical outlet.
To turn on the tool, slide the Power
3.
Switch (44) forward.
Do not allow contact between
4.
the Sanding Sheet (504), Angled
Scraper (4), or Blade (501, 503) and
workpiece until the tool is running at
full speed.
Avoid contact with foreign objects 5.
such as metal screws and nails when
sanding, scraping, or cutting.
Do not apply excessive pressure
6.
on the tool. Allow the tool to do the
work.
When finished, turn off the tool and
7.
allow it to completely stop before
setting it down. Then unplug the tool
from its electrical outlet.
To replace the Sanding Sheet, simply
8.
pull it off the pad and press a new
sheet in place.
Prior to storing the tool, remove the
9.
attachment and wipe it clean. Store
the Tool in a clean, dry, safe location
out of reach of children and other
unauthorized persons.
REV 10e