Avlink HX-341616 - Manual (Page 15)

Matrix Switcher Series—User Manual
14
ƒ Power Port: The Power Port is applicable for 100~240VAC, 50~60Hz connected to the
outlet of power source. Refer to
6.4 Power Connection .
ƒ Power Switch: To switch power ON or OFF the Matrix Switcher.
ƒ RS-232: Use a 9-pin RS-232 cable to connect both computer serial port (COM1 or
COM2) and Matrix Switcher RS-232 communication port, refer to
6.6.1 RS-232 .
The
computer then can be deployed to control the Matrix Switcher after installing of
application software. Refer to
7.1 Software Introduction
for a software control or
Appendix D RS-232 Communication Protocol
for an individual configuration.
ƒ RS-485: Connection ports allow you to connect/control more than one Matrix product,
refer to 6.6.2 RS-485.
ƒ LAN Port: Use the RJ45 connection cable to connect the Internet and the Matrix
Switcher. The entire PCs at the same network can control the Matrix Switcher through
the LAN port. Refer to
6.6.3 LAN Port.
ƒ Switchers: Matrix Switcher supports 8 pins DIP and 2 pins DIP switchers for
connected configurations. For more information, refer to
6.6 Ports and Switchers.
-
Pin 1~Pin5: ID
-
Pin 6: Master/Slave
-
Pin 7: RS-232/LAN
-
Pin 8: IP RESET
ƒ IR EXT: This is used to connect the IR Receiver Cable for the Matrix Switcher Remote
Controller. Refer to
6.3 IR EXT Connection.
ƒ INPUT1~4, 8 or 16: Matrix Switcher Input jacks are connected to the Blu-ray players,
DVD players, STBs or other source devices.
HDMI Type A: Pin Definitions:
Pin # Signal Pin # Signal
1 TMDS Data2+ 11 TMDS Clock Shield
2 TMDS Data2 Shield 12 TMDS Clock-
3 TMDS Data2- 13 CEC (NC on device)
4 TMDS Data1+ 14 Utility (NC on device)
5 TMDS Data1 Shield 15 DDC-SCL
6 TMDS Data1- 16 DDC-SDA
7 TMDS Data0+ 17 DDC-Ground
8 TMDS Data0 Shield 18 +5V Power
9 TMDS Data0- 19 Hot Plug Detect
10 TMDS Clock+