Appendix c: factory settings -7, I/o/status port address setting -7, Appendix c: factory settings – Connect Tech DFlex-4/104 User Manual
Page 57: Chapter c: appendix f - factory settings 4-7
Chapter C: Appendix F - Factory Settings
4-7
DFlex-4/104 User's Manual, ver. 0.04
Appendix C: Factory Settings
Appendix C summarizes the following factory settings for the
DFlex-4/104 adapter.
I/O Port address setting
IRQ (Interrupt Request Line)
I/O/Status Port Address Setting
Switch block S1 sets the I/O and status port addresses for the
DFlex-4/104 adapter. Connect Tech ships the DFlex-4/104
adapter with S1 set for I/O port addresses 200, 208, 210, 218 hex
and the status port disabled. Figure 8 shows the location and
factory setting of this jumper block.
Figure 8: I/O/Status port address factory settings
Port address
switch block
9/
2
10
11
4
5
SW
1
ON
1
2
3
6
Port address
switches
Status Port
switch