Antari M-8 - Manual (Page 6)

6
Setup
․ Remove all packing materials from shipping box. Check that all foam and plastic padding
is removed, especially in the nozzle area.
․ Place fog machine on a flat surface and remove fog liquid tank cap.
․ Fill with high-quality, water-based fog liquid recommended by Antari dealer.
․ When filled, place cap back on liquid tank.
․ Firmly attach the M-21 control module cable to the connector inside the rear chamber for
the machine.
Operation
․ Plug power cord into a grounded electrical outlet. Turn the power switch to “ON” on the
back of the machine. Warm-up is completed when the display on the control module
shows “Ready to Fog”
․ To emit fog press the appropriate button on the M-21 control module for fogging duration,
interval and volume
․ The control unit display will display “Warming up” and “Ready to fog” as the machine
re-heats to the proper operating temperature.
․ For further information on operating your M-8 Fog Machine, see the section titled
“Control Module Operation”
․ The limited warranty is based on 8-hour operation per day. Exceeding usage may
shorten the lifetime of machines.
Caution
”Visibility during operation is reduced” This model can be operated at a floor level or sitting
on any regular surface. Whatever installation method you choose, do not allow the unit to
have more than 35 degree angle of inclination.