Antari M-8 User Manual

Page 12

Setting Example 2:

In order to use 1 transmitter to control 2 or more machines, turn on the machines

respectively. When the displays indicate »Wireless Setup«, press the button “A” 1 second on

the transmitter within 15 seconds to establish the signal transmission.

-Battery change on the transmitter

If the range of the transmitter decreases, the battery is probably exhausted and must be

replaced. For this purpose, take off the housing cover and remove the used battery. Insert a

fresh DC 12V battery as indicated in the battery compartment and refit the housing cover.

․

Note: When warming-up process is completed and wireless function is activated the LCD

screen indicates “Ready To Fog W”. (“W” means Wireless) On the contrary, when the

wireless function is deactivated the LCD screen shows “Ready To Fog” (Without “W”).

DMX Connector Pin Assignment

The machine provide 3 or 5 pin XLR connector for DMX connection. Diagram below indicate

pin assignment information

Function

Ground

Data-

Data+